Firmware 1.30.29.20 — "multi-point turning" restored after being removed
- Models covered
- Luba (exact model line not specified in the source thread — thread title says "Luba," not a specific LUBA generation)
- Last verified
- 1 September 2026
This page isn't a rollback guide — it documents a report worth knowing about before you decide to roll back at all.
What was reported
An owner on roboter-forum.com reports that firmware 1.30.29.20 restored a feature called "multi-point turning" that had previously been removed in an earlier update. This is direct evidence that Mammotion sometimes removes a feature in one release and quietly brings it back in a later one.
Why this matters if you're considering a rollback
If you're missing a feature that used to work and are weighing whether to roll back firmware to get it back, it's worth checking recent release notes and forum threads first — there's a real, documented precedent for Mammotion restoring removed functionality in a subsequent update rather than you needing to revert.
Model attribution is uncertain. The source thread's title only says "Luba," without specifying which generation (LUBA 1, LUBA 2, or LUBA 3). We're flagging that ambiguity rather than guessing — if you can confirm which model this applies to, let us know.